|
|
| GE Fanuc |
The following GE Fanuc courses are available.
|
| GE Fanuc PLC |
| VersaMax™ or 90-30 PLCs |
Duration 1 day |
|---|
| Introduction to PLC's |
| Switches and Contacts, Circuits, Software Programming. |
| PLC Hardware (VersaMax™ or 90-30 PLCs) |
Programmable Controllers.
CPUs.
Local I/O.
System expansion options. |
| Software |
Introduction to Programming Software (VersaPro™).
Configuration: Auto or Programmer.
Racks and Slots.
Storing a Configuration. |
| Pre-Programming Information |
CPU Operation.
Standard Sweep / Constant Sweep modes.
Stop modes.
Privilege levels and Passwords.
Program execution.
Memory References and Memory Allocation. |
| Contacts & Coils |
Normally Open, Normally Closed, Continuation Contacts.
Negated, Positive / Negative Transition, Retentive / Set / Reset, Negated / Retentive, Continuation Coils. |
| Timers & Counters |
| On-Delay Stopwatch, Off and On Delay Timers.
Up / Down Counters. |
|
|
| |
| |
|
| All topics are reinforced with practical exercises throughout the course. |
|
|